The operation performance and production of the superfine grinding mill are closely related to the various accessories inside the equipment. The bearing is the key part, which is the core component to ensure the normal operation of the mill. Any kind of accessories will fail. This is an inevitable phenomenon when the ultra-fine mill is in use. In autumn and winter, due to climate reasons, the bearing will also encounter some failures. The most common one is after damp The problem of rust, the ultra-fine pulverizer is an outdoor working environment, and the machine will get damp from time to time when the machine is in use, and even if the equipment is running in the factory, the humid air after the rain will affect the steel such as the bearing of the superfine grinding mill. Products are also influential. Both of these conditions can cause rust. In order to prevent rust from adversely affecting the ultrafine grinding equipment, it must be treated in time. The following describes how to treat the bearing after being wet.

When the main bearing of the superfine grinding mill is rusty, you can apply a layer of lubricant on the surface according to the situation, or use fine sandpaper to find it. If the auxiliary bearing is rusty, you can consider replacing it. You can also put the bearing in diesel oil for a little time, and then polish it now. This is a common treatment method for superfine mill bearings after rust. It is not only simple and easy, but also can avoid rust. The impact of the mill operation.

The maintenance of the superfine grinding mill after operation is inevitable, but no matter what kind of maintenance measures are based on reducing production costs, although the bearings can be replaced, no one will choose it as a last resort This method, because it is not good for the reduction of production costs, and the rust of the bearings of ultra-fine pulverizers is a common problem, so when facing this problem, we should find ways to extend the service life of the bearings instead of replacing them. The rust of the bearing after being exposed to rain is mainly solved by the lubricants introduced above.

The shaft of the superfine grinding mill bears the full load of the negative machine, so good lubrication has a great relationship with the life of the bearing. It directly affects the service life and operating efficiency of the superfine grinding mill, so the injected lubricating oil is required to be  clean , Sealed  well. The main oil injection points of the ultra-fine mill are rotating bearings, roll bearings, all gears, movable bearings, and sliding planes.